Daikin logo

Daikin 9.4 kW split system

$3,400–$4,800

estimated installed price

RXM95P2VMA / FTXM95P2VMA
Daikin RXM95P2VMA / FTXM95P2VMA indoor unit
Image: Daikin. Shows this model family; sizes look alike

Cooling

9.4 kW

2.5 stars

Heating

10.3 kW

2 stars

Indoor noise

69

dB(A) sound power, quieter than 3% of its size

Running cost

$818

a year, average zone, at 33c/kWh

Short answer

The Daikin 9.4 kW split system (RXM95P2VMA / FTXM95P2VMA) is a 9.4 kW reverse cycle wall split rated 2.5 stars for cooling and 2 stars for heating in the average climate zone. Installed, expect $3,400 to $4,800; the label's figures put running costs near $818 a year in an average-zone home.

Prices are estimates, not quotes (how we estimate them). Rebate rules checked September 2026.

Compare 3 quotes for my house

Full specifications

Brand
Daikin
Model numbers
RXM95P2VMA / FTXM95P2VMA
Type
Wall split, reverse cycle (heats and cools)
Cooling capacity
9.4 kW
Cooling power input
2.75 kW
Heating capacity
10.3 kW
Heating power input
3.07 kW
Annual efficiency, cooling (AEER)
3.33
Annual efficiency, heating (ACOP)
3.28
Indoor sound power
69 dB(A)
Outdoor sound power
66 dB(A)
Refrigerant
R32
Power supply
Single-phase
Demand response capable
Yes
Country of manufacture
Thailand
Energy Rating registration
AAC6540
Registration valid until
2027-03-01

Star ratings and running cost by climate

The Zoned Energy Rating Label rates each unit for three climates. Annual energy is the label's estimate for typical use in that zone; the cost applies 33c/kWh, around the 2026–27 default electricity offer. Use the running cost calculator for your own hours and tariff.

Climate zone Cooling stars Heating stars Energy a year Cost a year
HotBrisbane, Darwin 3 stars 2.5 stars 2,860 kWh 2606 cooling, 254 heating $944
AverageSydney, Adelaide, Perth 2.5 stars 2 stars 2,477 kWh 929 cooling, 1548 heating $818
ColdCanberra, Hobart, Melbourne 2.5 stars 1.5 stars 4,788 kWh 600 cooling, 4188 heating $1,580

How it compares with other 9 kW and up units

See the quietest and most efficient rankings.

Alternatives at 9 kW and up from other brands

FAQ

Daikin RXM95P2VMA / FTXM95P2VMA: common questions

How much does the Daikin 9.4 kW split system cost installed?

Typically $3,400 to $4,800 supplied and installed in 2026 for a standard job at this size. Longer pipe runs, a new circuit, a second storey or removing an old unit add to it. Get up to three local quotes for your actual install.

How much does the Daikin 9.4 kW split system cost to run?

Using the energy label's annual figures at 33c/kWh: about $944 a year in a hot zone, $818 in an average zone and $1,580 in a cold zone. The label assumes typical use; yours will differ with hours, set temperature and insulation.

Where is the Daikin RXM95P2VMA / FTXM95P2VMA made?

The Energy Rating register lists the country of manufacture as Thailand.

Is the Daikin 9.4 kW split system quiet?

Its registered indoor sound power is 69 dB(A), against a median of 64.8 dB(A) for 9 kW and up wall split units, so it's quieter than about 3% of them. Brochures quote a lower sound pressure figure on the lowest fan speed; the register measures every model the same way.

Sources

Brand names and logos are trademarks of their owners, shown to identify the brands we compare. We are independent and not affiliated with any manufacturer.

A quiet Australian living room

Get quotes for your air con

Free and takes about two minutes. Check your rebate, then up to three licensed local installers quote the job.

Compare 3 quotes