Rinnai logo

Rinnai PB Series 2.6 kW split system

$1,500–$2,500

estimated installed price

HSNRP26B
Rinnai PB Series indoor unit
Image: Rinnai. Shows the Rinnai PB Series range; sizes look alike

Cooling

2.6 kW

5.5 stars

Heating

2.7 kW

3.5 stars

Indoor noise

55.3

dB(A) sound power, quieter than 34% of its size

Running cost

$140

a year, average zone, at 33c/kWh

Short answer

The Rinnai PB Series 2.6 kW split system (HSNRP26B) is a 2.6 kW reverse cycle wall split rated 5.5 stars for cooling and 3.5 stars for heating in the average climate zone. Installed, expect $1,500 to $2,500; the label's figures put running costs near $140 a year in an average-zone home.

Prices are estimates, not quotes (how we estimate them). Rebate rules checked September 2026.

Compare 3 quotes for my house

Full specifications

Brand
Rinnai
Series
Rinnai PB Series
Model numbers
HSNRP26B
Type
Wall split, reverse cycle (heats and cools)
Cooling capacity
2.6 kW
Cooling power input
0.53 kW
Heating capacity
2.7 kW
Heating power input
0.51 kW
Annual efficiency, cooling (AEER)
4.98
Annual efficiency, heating (ACOP)
5.27
Indoor sound power
55.3 dB(A)
Outdoor sound power
57.8 dB(A)
Refrigerant
R32
Power supply
Single-phase
Demand response capable
Yes
Country of manufacture
China
Energy Rating registration
AAC7708
Registration valid until
2028-08-15

Star ratings and running cost by climate

The Zoned Energy Rating Label rates each unit for three climates. Annual energy is the label's estimate for typical use in that zone; the cost applies 33c/kWh, around the 2026–27 default electricity offer. Use the running cost calculator for your own hours and tariff.

Climate zone Cooling stars Heating stars Energy a year Cost a year
HotBrisbane, Darwin 6.5 stars 4 stars 473 kWh 432 cooling, 41 heating $157
AverageSydney, Adelaide, Perth 5.5 stars 3.5 stars 424 kWh 148 cooling, 276 heating $140
ColdCanberra, Hobart, Melbourne 6 stars 3 stars 805 kWh 93 cooling, 712 heating $266

How it compares with other 2.5 kW units

See the quietest and most efficient rankings.

Other sizes in the Rinnai PB Series range

Alternatives at 2.5 kW from other brands

FAQ

Rinnai HSNRP26B: common questions

How much does the Rinnai PB Series 2.6 kW split system cost installed?

Typically $1,500 to $2,500 supplied and installed in 2026 for a standard job at this size. Longer pipe runs, a new circuit, a second storey or removing an old unit add to it. Get up to three local quotes for your actual install.

How much does the Rinnai PB Series 2.6 kW split system cost to run?

Using the energy label's annual figures at 33c/kWh: about $157 a year in a hot zone, $140 in an average zone and $266 in a cold zone. The label assumes typical use; yours will differ with hours, set temperature and insulation.

Where is the Rinnai HSNRP26B made?

The Energy Rating register lists the country of manufacture as China.

Is the Rinnai PB Series 2.6 kW split system quiet?

Its registered indoor sound power is 55.3 dB(A), against a median of 54.5 dB(A) for 2.5 kW wall split units, so it's quieter than about 34% of them. Brochures quote a lower sound pressure figure on the lowest fan speed; the register measures every model the same way.

Sources

Brand names and logos are trademarks of their owners, shown to identify the brands we compare. We are independent and not affiliated with any manufacturer.

A quiet Australian living room

Get quotes for your air con

Free and takes about two minutes. Check your rebate, then up to three licensed local installers quote the job.

Compare 3 quotes